Erik Carlson (erik@erik.co.uk)
Mon, 4 Jan 1999 10:59:04 +0000
Hello all hope you can help,
i I have completed the installation according to the demon sys
instructions, i think that the only thing i did not do was turn the key
to maintenance mode as i did not see the reasoning behind it.
Anyway , i did the copy from external to internal drive, edited the fstab,
made a proc directory and ran quik.
I then changed the open firmware to boot-device scsi-int/I then changed the open firmware to boot-device scsi-int/sd@0:0 and
boot-file /boot/vmlinux root=/dev/sda3
When I type boot i get:
scsi-int/scsi-int/sd@0:0 Second Stage QUIK Loader
Couldn't Open /bandit/Couldn't Open /bandit/53C825@11/Couldn't Open /bandit/53C825@11/sd@0
probe-scsi1 reports that the drive is present.
This sounds similar to the problems reported in the "Errors with internal
drive" thread but none of them quite matched mine.
if it try boot scsi-int/if it try boot scsi-int/sd@0:0,0 then i get a message about bad partition
number, quik then kicks in and fails at the same point as before.
Does anybody have any ideas, I am utterly stumped.
Thanks
Erik
--- Erik Carlson BEng (Hons), Network Support Engineer Mailbox Internet Ltd, 163 New Kings Rd, Fulham, London SW6 4SN TEL: 0171 371 8558 FAX: 0171 736 9253 EMAIL: erik@mailbox.net.uk WEB: http://www.mailbox.net.uk
This archive was generated by hypermail 2.0b3 on Mon Jan 04 1999 - 03:00:49 PST