Scott R. Every (scott@emji.net)
Fri, 16 Apr 1999 20:32:20 -0400
I have recently tried to get an SMC etherpower pro card working in the PCI
slot(#2) of my ANS 700. After compiling the driver into the kernel I get
the following:
The PCI BIOS has not enabled this device! Updating PCI command
0004->0005.
tulip.c:v0.89H 5/23/98 becker@cesdis.gsfc.nasa.gov
eth1: Digital DS21140 Tulip at 0x400, e0 00 10 29 84 77, IRQ 24.
eth1: MII transceiver found at MDIO address 3, config 3100 status 782b.
eth1: Advertising 01e1 on PHY 3, previously advertising 01e1.
Other than the first line, it looks fairly promising. Any ideas what the
first line signifies? Is there perhaps some OF setup which needs to be
done? The card did not work although ifconfig was apparently able to see
it and configure it, I couldn't get any traffic to go over the interface
either at 10 or 100 speeds.
If anyone has gotten this to work or has any suggestions, I would
appreciate
any advice.
thanx
s
-- Scott R. Every - mailto:scott@emji.net EMJ Internet - http://www.emji.net voice : 1-888-258-8959 fax : 1-919-363-4425
This archive was generated by hypermail 2.0b3 on Fri Apr 16 1999 - 18:24:44 PDT