Scott R. Every (scott@emji.net)
Sun, 18 Apr 1999 21:48:06 -0400
Forgot 1 thing. to use the new tulip.c file just replace the old one in
linux/drivers/net and re-compile your kernel or modules depending on how
you want to load it...
good luck...
s
--On Fri, Apr 16, 1999 8:32 PM -0400 "Scott R. Every" <scott@emji.net>
wrote:
> I have recently tried to get an SMC etherpower pro card working in the PCI
> slot(#2) of my ANS 700. After compiling the driver into the kernel I get
> the following:
> The PCI BIOS has not enabled this device! Updating PCI command
> 0004->0005.
> tulip.c:v0.89H 5/23/98 becker@cesdis.gsfc.nasa.gov
> eth1: Digital DS21140 Tulip at 0x400, e0 00 10 29 84 77, IRQ 24.
> eth1: MII transceiver found at MDIO address 3, config 3100 status 782b.
> eth1: Advertising 01e1 on PHY 3, previously advertising 01e1.
>
> Other than the first line, it looks fairly promising. Any ideas what the
> first line signifies? Is there perhaps some OF setup which needs to be
> done? The card did not work although ifconfig was apparently able to see
> it and configure it, I couldn't get any traffic to go over the interface
> either at 10 or 100 speeds.
>
> If anyone has gotten this to work or has any suggestions, I would
> appreciate
> any advice.
>
> thanx
>
> s
>
>
> --
> Scott R. Every - mailto:scott@emji.net
> EMJ Internet - http://www.emji.net
> voice : 1-888-258-8959 fax : 1-919-363-4425
-- Scott R. Every - mailto:scott@emji.net EMJ Internet - http://www.emji.net voice : 1-800-548-2319 fax : 1-919-363-4423
This archive was generated by hypermail 2.0b3 on Sun Apr 18 1999 - 18:50:18 PDT